homebrewtalk.com forum

Currently I gravity feed my immersion chiller. I’ve used a pump in the past, but from what I’ve discovered it isn’t the rate of water that is effecting the rate at which i can chill the beer (gravity is just fine) it is the amount of wort that comes in contact with the beer. So to help things along I’ve been stirring with a spoon. I’m working on adding a pump into my brewing setup to make life easier on me, but I’m not too sure how to go about priming the pump. I plan to have a simple inlet and outlet pipes with 90 bends to push the water around and through the coils of the chiller. I’m not going for a whirlpool affect, at least for now, with my wimpy pump but am just trying to move the wort around the coils without me stirring. For the record i have a valve on my kettle, but I don’t want to use that as I have a filter around it that I want to keep clear until I transfer to the primary. . Anybody have any suggestions of how to go about priming my setup? I know adding another valve would solve my problem, but I’m looking for other ideas as I’m not too keen on this idea as I want this idea to work with several other kettles. Thanks.

Priming Suggestion